Figure 216 Security > Vpn > Vpn Rules (Manual); Table 106 Security > Vpn > Vpn Rules (Manual) - ZyXEL Communications ZYWALL 35 User Manual

Figure 216 SECURITY > VPN > VPN Rules (Manual)
The following table describes the labels in this screen.
Table 106 SECURITY > VPN > VPN Rules (Manual)
LABEL
#
Name
Active
Local Network
Remote Network
Encap.
IPSec Algorithm
Remote Gateway
Address
ZyWALL 5/35/70 Series User's Guide
DESCRIPTION
This is the VPN policy index number.
This field displays the identification name for this VPN policy.
This field displays whether the VPN policy is active or not. A Yes signifies that this
VPN policy is active. No signifies that this VPN policy is not active.
This is the IP address(es) of computer(s) on your local network behind your
ZyWALL.
The same (static) IP address is displayed twice when the Local Network Address
Type field in the VPN - Manual Key - Edit screen is configured to Single Address.
The beginning and ending (static) IP addresses, in a range of computers are
displayed when the Local Network Address Type field in the VPN - Manual Key -
Edit screen is configured to Range Address.
A (static) IP address and a subnet mask are displayed when the Local Network
Address Type field in the VPN - Manual Key - Edit screen is configured to
Subnet Address.
This is the IP address(es) of computer(s) on the remote network behind the remote
IPSec router.
This field displays N/A when the Remote Gateway Address field displays 0.0.0.0.
In this case only the remote IPSec router can initiate the VPN.
The same (static) IP address is displayed twice when the Remote Network
Address Type field in the VPN - Manual Key - Edit screen is configured to Single
Address.
The beginning and ending (static) IP addresses, in a range of computers are
displayed when the Remote Network Address Type field in the VPN - Manual
Key - Edit screen is configured to Range Address.
A (static) IP address and a subnet mask are displayed when the Remote Network
Address Type field in the VPN - Manual Key - Edit screen is configured to
Subnet Address.
This field displays Tunnel or Transport mode (Tunnel is the default selection).
This field displays the security protocols used for an SA.
Both AH and ESP increase ZyWALL processing requirements and
communications latency (delay).
This is the static WAN IP address of the remote IPSec router.
Chapter 18 IPSec VPN
381