Zywall With Netscreen Vpn Tunneling - ZyXEL Communications ZYWALL 1050 Support Notes

1.2.2.2 ZyWALL with NetScreen VPN Tunneling

This section guides how to setup a VPN connection between the ZyWALL 1050/ZyWALL
USG 300 and NetScreen 5GT.
As on the figure below, the tunnel between Central and Remote offices ensures the packet
flows between them are secure. This is because the packets flowing through the IPSec tunnel
are encrypted. The required settings to setup this VPN tunnel using ZyWALL and NetScreen
are stated in the following section.
Central Office Gateway
ZyWALL
LAN: 192.168.1.X
The central office gateway ZyWALL 1050's interface and VPN setting retain the same settings
as in the previous example. If you jumped to this section first, please refer to 'ZyWALL1050
to ZYWALL70 VPN tunnel setting' on the page 8.
This list below is to briefly show the VPN phase1 and phase2 configuration parameters:
ZyWALL
WAN: 210.110.7.1
LAN: 192.168.1.0/24
Negotiation Mode : Main
Pre-share key: 123456789
Encryption :DES
Authentication :MD5
Key Group :DH1
All contents copyright (c) 2007 ZyXEL Communications Corporation.
ZyWALL 1050/ZyWALL USG 300 Support Notes
Static IP address
210.110.7.1
Internet
Phase 1
Static IP address
167.35.4.3
Branch Gateway
NetScreen 5GT
LAN: 192.168.2.X
NetScreen
WAN: 167.35.4.3
LAN: 192.168.2.0/24
Phase 1
Negotiation Mode : Main
Pre-share key: 123456789
Encryption :DES
Authentication :MD5
Key Group :DH1
32