Log Commands; Configuring What You Want The Prestige To Log; Figure 222 Displaying Log Categories Example; Figure 223 Displaying Log Parameters Example - ZyXEL Communications PRESTIGE 2602R Series User Manual

Prestige 2602R Series User's Guide
Table 124 RFC-2408 ISAKMP Payload Types (continued)

Log Commands

Go to the command interpreter interface
use the commands).

Configuring What You Want the Prestige to Log

1 Use the sys logs load command to load the log setting buffer that allows you to configure
which logs the Prestige is to record.
2 Use sys logs category to view a list of the log categories.

Figure 222 Displaying Log Categories Example

Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys
ip
dsp
ras>
3 Use sys logs category followed by a log category to display the parameters that are
available for the category.

Figure 223 Displaying Log Parameters Example

ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both]
ras>
4 Use sys logs category followed by a log category and a parameter to decide what to
record.
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to
record only alerts for that category, and 3 to record both logs and alerts for that category.
Not every parameter is available with every category.
5 Use the sys logs save command to store the settings in the Prestige (you must do this in
order to record logs).
339
LOG DISPLAY
DEL
VID
(Appendix Fon page 328
exit ether
bridge lan
voiceradius
PAYLOAD TYPE
Delete
Vendor ID
explains how to access and
wan
Appendix H Log Descriptions