Tftp Upload Command Example; Uploading Via Console Port; Uploading Firmware File Via Console Port; Figure 168 Menu 24.7.1 As Seen Using The Console Port - ZyXEL Communications PRESTIGE 2602R Series User Manual

30.4.6 TFTP Upload Command Example

The following is an example TFTP command:
where " " specifies binary image transfer mode (use this mode when transferring binary files),
i
" " is the Prestige's IP address and "
host
(
firmware.bin
remote host (
Commands that you may see in GUI-based TFTP clients are listed earlier in this chapter.

30.4.7 Uploading Via Console Port

Note: The console port is internal and reserved for technician use only.
FTP or TFTP are the preferred methods for uploading firmware to your Prestige. However, in
the event of your network being down, uploading files is only possible with a direct
connection to your Prestige via the console port. Uploading files via the console port under
normal conditions is not recommended since FTP or TFTP is faster. Any serial
communications program should work fine; however, you must use the Xmodem protocol to
perform the download/upload.

30.4.7.1 Uploading Firmware File Via Console Port

1 Select 1 from Menu 24.7 – System Maintenance – Upload Firmware to display Menu
24.7.1 - System Maintenance - Upload System Firmware, and then follow the instructions
as shown in the following screen.

Figure 168 Menu 24.7.1 As Seen Using the Console Port

2 After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on
your computer. Follow the procedure as shown previously for the HyperTerminal
program. The procedure for other serial communications programs should be similar.
Chapter 30 Firmware and Configuration File Maintenance
tftp [-i] host put firmware.bin ras
– name of the firmware on the computer) to the file destination on the
- name of the firmware on the Prestige).
ras
Menu 24.7.1 - System Maintenance - Upload System Firmware
To upload system firmware:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart
the router.
Warning: Proceeding with the upload will erase the current
system firmware.
Do You Wish To Proceed:(Y/N)
Prestige 2602R Series User's Guide
" transfers the file source on the computer
put
240