ZyXEL Communications PRESTIGE 2602R Series User Manual page 38

• Supports Multi-Mode standard (ANSI T1.413, Issue 2; G.dmt (G.992.1); G.lite
(G992.2)).
• TCP/IP (Transmission Control Protocol/Internet Protocol) network layer protocol.
• ATM Forum UNI 3.1/4.0 PVC.
• Supports up to 8 PVCs (UBR, CBR, VBR).
• Multiple Protocol over AAL5 (RFC 1483).
• PPP over AAL5 (RFC 2364).
• PPP over Ethernet over AAL5 (RFC 2516).
• RFC 1661.
• PPP over PAP (RFC 1334).
• PPP over CHAP (RFC 1994).
Protocol Support
• DHCP Support
DHCP (Dynamic Host Configuration Protocol) allows the individual clients (computers)
to obtain the TCP/IP configuration at start-up from a centralized DHCP server. The
Prestige has built-in DHCP server capability enabled by default. It can assign IP
addresses, an IP default gateway and DNS servers to DHCP clients. The Prestige can now
also act as a surrogate DHCP server (DHCP Relay) where it relays IP address assignment
from the actual real DHCP server to the clients.
• PPP (Point-to-Point Protocol) link layer protocol.
• Transparent bridging for unsupported network layer protocols.
• RIP I/RIP II
• IGMP Proxy
• ICMP support
• ATM QoS support
• MIB II support (RFC 1213)
IP Alias
IP Alias allows you to partition a physical network into logical networks over the same
Ethernet interface. The Prestige supports three logical LAN interfaces via its single physical
Ethernet interface with the Prestige itself as the gateway for each LAN network.
IP Policy Routing (IPPR)
Traditionally, routing is based on the destination address only and the router takes the shortest
path to forward a packet. IP Policy Routing (IPPR) provides a mechanism to override the
default routing behavior and alter the packet forwarding based on the policy defined by the
network administrator.
Chapter 1 Getting To Know Your Prestige
Prestige 2602R Series User's Guide
38