Traffic Redirect Setup; Figure 78 Menu 2.1Traffic Redirect Setup; Table 41 Menu 2 Wan Backup Setup; Table 42 Menu 2.1Traffic Redirect Setup - ZyXEL Communications PRESTIGE 2602R Series User Manual

Prestige 2602R Series User's Guide
Table 41 Menu 2 WAN Backup Setup (continued)
FIELD
Recovery Interval(sec) When the Prestige is using a lower priority connection (usually a WAN backup
ICMP Timeout
Traffic Redirect
When you have completed this menu, press [ENTER] at the prompt "
or ESC to Cancel:

20.2.1 Traffic Redirect Setup

Configure parameters that determine when the Prestige will forward WAN traffic to the
backup gateway using Menu 2.1 — Traffic Redirect Setup.
Figure 78
The following table describes the fields in this menu.

Table 42 Menu 2.1Traffic Redirect Setup

FIELD
Active.
Configuration
Backup Gateway
IP Address
Metric
When you have completed this menu, press [ENTER] at the prompt "
or ESC to Cancel:
155
DESCRIPTION
connection), it periodically checks to whether or not it can use a higher priority
connection.
Type the number of seconds (30 recommended) for the Prestige to wait
between checks. Allow more time if your destination IP address handles lots of
traffic.
Type the number of seconds for an ICMP session to wait for the ICMP
response
Press [SPACE BAR] to select Yes or No.
Select Yes and press [ENTER] to configure Menu 2.1 Traffic Redirect Setup.
Select No (default) if you do not want to configure this feature.
" to save your configuration, or press [ESC] at any time to cancel.
Menu 2.1Traffic Redirect Setup
Menu 2.1 - Traffic Redirect Setup
Active= No
Configuration:
Backup Gateway IP Address= 0.0.0.0
Metric= 15
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic redirect
setup. The default is No
Enter the IP address of your backup gateway in dotted decimal notation.
The Prestige automatically forwards traffic to this IP address if the Prestige's
Internet connection terminates.
This field sets this route's priority among the routes the Prestige uses.
The metric represents the "cost of transmission". A router determines the best route
for transmission by choosing a path with the lowest "cost". RIP routing uses hop
count as the measurement of cost, with a minimum of "1" for directly connected
networks. The number must be between "1" and "15"; a number greater than "15"
means the link is down. The smaller the number, the lower the "cost"
" to save your configuration, or press [ESC] at any time to cancel.
Press ENTER to Confirm
Press ENTER to Confirm
Chapter 20 Menu 2 WAN Backup Setup