Remote Node Configuration; Remote Node Setup Overview; Remote Node Setup; Remote Node Profile - ZyXEL Communications PRESTIGE 2602R Series User Manual

Remote Node Configuration

23.1 Remote Node Setup Overview

This section describes the protocol-independent parameters for a remote node. A remote node
is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. When you use menu 4 to set up
Internet access, you are configuring one of the remote nodes.
You first choose a remote node in Menu 11- Remote Node Setup. You can then edit that
node's profile in menu 11.1, as well as configure specific settings in three submenus: edit IP
and bridge options in menu 11.3; edit ATM options in menu 11.6; and edit filter sets in menu
11.5.
23.2

Remote Node Setup

This section describes the protocol-independent parameters for a remote node.
23.2.1

Remote Node Profile

To configure a remote node, follow these steps:
1 From the main menu, enter 11 to display Menu 11 - Remote Node Setup.
2 When menu 11 appears, as shown in the following figure, type the number of the remote
node that you want to configure.
Chapter 23 Remote Node Configuration
Prestige 2602R Series User's Guide
C
H A P T E R
2 3
166