Static Route Setup Screen - ZyXEL Communications NBG-417N - V1.0 Manual

Table 50 Management > Static Route > IP Static Route
LABEL
Gateway
Modify

15.3.1 Static Route Setup Screen

To edit a static route, click the edit icon under Modify. The following screen
displays. Fill in the required information for each static route.
Figure 79 Management > Static Route > IP Static Route: Static Route Setup
The following table describes the labels in this screen.
Table 51 Management > Static Route > IP Static Route: Static Route Setup
LABEL
Route Name
Active
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
NBG-417N User's Guide
DESCRIPTION
This is the IP address of the gateway. The gateway is an immediate
neighbor of your NBG-417N that will forward the packet to the
destination. On the LAN, the gateway must be a router on the same
segment as your NBG-417N; over the WAN, the gateway must be the
IP address of one of the remote nodes.
Click the Edit icon to open the static route setup screen. Modify a static
route or create a new static route in the Static Route Setup screen.
Click the Remove icon to delete a static route.
DESCRIPTION
Enter the name of the IP static route. Leave this field blank to delete
this static route.
This field allows you to activate/deactivate this static route.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a
route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the
host ID.
Enter the IP subnet mask here.
Enter the IP address of the gateway. The gateway is an immediate
neighbor of your NBG-417N that will forward the packet to the
destination. On the LAN, the gateway must be a router on the same
segment as your NBG-417N; over the WAN, the gateway must be the IP
address of one of the Remote Nodes.
Chapter 15 Static Route
149