ZyXEL Communications NBG-417N - V1.0 Manual page 106

Chapter 8 WAN
The following table describes the labels in this screen.
Table 37 WAN > Advanced
LABEL
Multicast Setup
Multicast
Windows Networking (NetBIOS over TCP/IP)
Allow between LAN
and WAN
Allow Trigger Dial
Auto-bridge
Enable Auto-bridge
mode
Apply
Reset
106
DESCRIPTION
Check this to enable multicasting. This applies to traffic routed from
the WAN to the LAN.
Leaving this blank may cause incoming traffic to be dropped or sent
to all connected network devices.
Select this check box to forward NetBIOS packets from the LAN to
the WAN and from the WAN to the LAN. If your firewall is enabled
with the default policy set to block WAN to LAN traffic, you also
need to enable the default WAN to LAN firewall rule that forwards
NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the
LAN to the WAN and from the WAN to the LAN.
Select this option to allow NetBIOS packets to initiate calls.
Select this option to have the NBG-417N switch to bridge mode
automatically when the NBG-417N gets a WAN IP address in the
range of 192.168.x.y (where x and y are from zero to nine) no
matter what the LAN IP address is.
Click Apply to save your changes back to the NBG-417N.
Click Reset to begin configuring this screen afresh.
NBG-417N User's Guide