General Screen; Advanced Screen - ZyXEL Communications NBG-417N - V1.0 Manual

Wireless n-lite home router
Table of Contents

Advertisement

Chapter 10 DHCP Server

10.4 General Screen

Use this screen to enable the DHCP server. Click Network > DHCP Server. The
following screen displays.
Figure 62 Network > DHCP Server > General
The following table describes the labels in this screen.
Table 39 Network > DHCP Server > General
LABEL
Enable DHCP
Server
IP Pool Starting
Address
Pool Size
Apply
Reset

10.5 Advanced Screen

This screen allows you to assign IP addresses on the LAN to specific individual
computers based on their MAC addresses. You can also use this screen to
configure the DNS server information that the NBG-417N sends to the DHCP
clients.
112
DESCRIPTION
Enable or Disable DHCP for LAN.
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC
2132) allows individual clients (computers) to obtain TCP/IP
configuration at startup from a server. Leave the Enable DHCP
Server check box selected unless your ISP instructs you to do
otherwise. Clear it to disable the NBG-417N acting as a DHCP
server. When configured as a server, the NBG-417N provides TCP/IP
configuration for the clients. If not, DHCP service is disabled and
you must have another DHCP server on your LAN, or else the
computers must be manually configured. When set as a server, fill in
the following four fields.
This field specifies the first of the contiguous addresses in the IP
address pool for LAN.
This field specifies the size, or count of the IP address pool for LAN.
Click Apply to save your changes back to the NBG-417N.
Click Reset to begin configuring this screen afresh.
NBG-417N User's Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nbg-417n

Table of Contents