Chapter 5 AP Mode
To set your NBG-417N to AP Mode, go to Maintenance > Sys OP Mode >
2
General and select Access Point.
Figure 24 Maintenance > Sys OP Mode > General
A pop-up appears providing information on this mode. Click OK in the pop-up
3
message window. (See
pop-up.) Click Apply. Your NBG-417N is now in AP Mode.
Note: You have to log in to the Web Configurator again when you change modes.
5.3 The Status Screen in AP Mode
Click on Status. The screen below shows the status screen in AP Mode.
Figure 25 Status: AP Mode
54
Section 22.4 on page 193
for more information on the
NBG-417N User's Guide