Pppoe Encapsulation - ZyXEL Communications NBG-417N - V1.0 Manual

Chapter 8 WAN
Table 34 Network > WAN > Internet Connection: Ethernet Encapsulation
LABEL
IP Address
IP Subnet
Mask
Gateway IP
Address
DNS Servers
First DNS Server
Second DNS
Server
WAN MAC
Address
Factory default
Clone the
computer's MAC
address - IP
Address
Set WAN MAC
Address
Apply
Reset

8.4.2 PPPoE Encapsulation

The NBG-417N supports PPPoE (Point-to-Point Protocol over Ethernet). PPPoE is
an IETF standard (RFC 2516) specifying how a personal computer (PC) interacts
with a broadband modem (DSL, cable, wireless, etc.) connection. The PPP over
Ethernet option is for a dial-up connection using PPPoE.
For the service provider, PPPoE offers an access and authentication method that
works with existing access control systems (for example Radius).
100
DESCRIPTION
Enter your WAN IP address in this field if you selected Use Fixed IP
Address.
Enter the IP Subnet Mask in this field.
Enter a Gateway IP Address (if your ISP gave you one) in this field.
Select From ISP if your ISP dynamically assigns DNS server
information (and the NBG-417N's WAN IP address). The field to the
right displays the (read-only) DNS server IP address that the ISP
assigns.
Select User-Defined if you have the IP address of a DNS server. Enter
the DNS server's IP address in the field to the right. If you chose User-
Defined, but leave the IP address set to 0.0.0.0, User-Defined
changes to None after you click Apply. If you set a second choice to
User-Defined, and enter the same IP address, the second User-
Defined changes to None after you click Apply.
Select None if you do not want to configure DNS servers. If you do not
configure a DNS server, you must know the IP address of a computer in
order to access it.
The MAC address section allows users to configure the WAN port's MAC
address by either using the NBG-417N's MAC address, copying the MAC
address from a computer on your LAN or manually entering a MAC
address.
Select Factory default to use the factory assigned default MAC
Address.
Select Clone the computer's MAC address - IP Address and enter
the IP address of the computer on the LAN whose MAC you are cloning.
Once it is successfully configured, the address will be copied to the rom
file. It will not change unless you change the setting or upload a
different ROM file.
Select this option and enter the MAC address you want to use.
Click Apply to save your changes back to the NBG-417N.
Click Reset to begin configuring this screen afresh.
NBG-417N User's Guide