Wps Station Screen; Scheduling Screen - ZyXEL Communications NBG-417N - V1.0 Manual

Chapter 7 Wireless LAN

7.9 WPS Station Screen

Use this screen when you want to add a wireless station using WPS. To open this
screen, click Network > Wireless LAN > WPS Station tab.
Note: Note: After you click Push Button on this screen, you have to press a similar
button in the wireless station utility within 2 minutes. To add the second wireless
station, you have to press these buttons on both device and the wireless station
again after the first 2 minutes.
Figure 51 WPS Station
The following table describes the labels in this screen.
Table 32 WPS Station
LABEL
Push Button
Or input
station's PIN
number

7.10 Scheduling Screen

Use this screen to set the times your wireless LAN is turned on and off. Wireless
LAN scheduling is disabled by default. The wireless LAN can be scheduled to turn
92
DESCRIPTION
Use this button when you use the PBC (Push Button Configuration)
method to configure wireless stations's wireless settings. See
6.2.1 on page 62.
Click this to start WPS-aware wireless station scanning and the wireless
security information synchronization.
Use this button when you use the PIN Configuration method to
configure wireless station's wireless settings. See
63.
Type the same PIN number generated in the wireless station's utility.
Then click Start to associate to each other and perform the wireless
security information synchronization.
Section
Section 6.2.2 on page
NBG-417N User's Guide