JLL IC 200 PRO Instruction Manual page 11

IC200 PRO ASSEMBLY
The bike has been assembled and tested at the factory, so you shouldn't have any
problems putting all the parts together. Components are designed to fit together, and
only basic tools are required for the assembly process. Inside the box you will find a Tools
Pack (Hex Allen Key, Multi-tool, Washers and Bolts). See previous page.
To assemble your JLL IC200 PRO please follow these easy steps:
STEP 1
Attach the front and rear stabilizers to
the main frame using 4 x M8*20 Screws
(Part 9), 4 x spring washers and 4 x flat
washers.
STEP 3
Attach the handlebars to the
handlebar post by feeding the wire
through the post and securing using 3
x M8*16 Screws, 3 x spring washers and
3 x flat washers.
STEP 2
Attach the right and left pedals to their
corresponding cranks, turn the right
pedal clockwise and the left
anti-clockwise.
STEP 4
Loosen the adjustment knob on the
front of the bike and insert the
handebar post into the frame also
feeding the wire through. Then tighten
the knob back up.
11