Mvr Group Configuration - ZyXEL Communications Dimension GS-2024 User Manual

Table 38 MVR (continued)
LABEL
Mode
Port
Source Port
Receiver Port
None
Tagging
Add
Cancel
VLAN
Active
Name
Mode
Source Port
Receiver Port
Delete
Cancel

18.7 MVR Group Configuration

All source ports and receiver ports belonging to a multicast group can receive multicast data
sent to this multicast group.
Configure MVR IP multicast group address(es) in the Group Configuration screen. Click
Group Configuration in the MVR screen.
Note: A port can belong to more than one multicast VLAN. However, IP multicast
group addresses in different multicast VLANs cannot overlap.
Chapter 18 Multicast
DESCRIPTION
Specify the MVR mode on the switch. Choices are Dynamic and Compatible.
Select Dynamic to send IGMP reports to all MVR source ports in the multicast
VLAN.
Select Compatible to set the switch not to send IGMP reports.
This field displays the port number on the switch.
This field is applicable for Ethernet ports.
Select this option to set this port as the MVR source port that sends and receives
multicast traffic.
Select this option to set this port as a receiver port that only receives multicast
traffic.
Select this option to set the port not to participate in MVR. No MVR multicast traffic
is sent or received on this port.
Select this checkbox if you want the port to tag the VLAN ID in all outgoing frames
transmitted.
Click Add to save the settings.
Click Cancel to discard all changes.
This field displays the multicast VLAN ID.
This field displays whether the multicast group is enabled or not.
This field displays the descriptive name for this setting.
This field displays the MVR mode.
This field displays the source port number(s).
This field displays the receiver port number(s).
To delete a multicast VLAN, select the VLAN(s) that you want to remove in the
Delete column, then click the Delete button.
Click Cancel to clear the Delete check boxes.
GS-2024 User's Guide
131