Dynamic Entries (Dvlan Table); Configuring Tagged Vlan; Figure 133 Tagged Vlan Configuration And Activation Example - ZyXEL Communications Dimension GS-2024 User Manual

GS-2024 User's Guide

29.2.2 Dynamic Entries (DVLAN Table)

Dynamic entries are learned by the switch and cannot be created or updated by administrators.
The switch learns this information by observing what port, source address and VLAN ID (or
VID) is associated with a frame. Entries are added and deleted using GARP VLAN
Registration Protocol (GVRP), where GARP is the Generic Attribute Registration Protocol.

29.3 Configuring Tagged VLAN

The following procedure shows you how to configure tagged VLAN.
1 Use the IEEE 802.1Q tagged VLAN commands to configure tagged VLAN for the
switch.
• Use the
switch automatically enters the
deactivate the VLAN(s).
• Use the
interface mode to set the VLAN settings on a port, then use the pvid <vlan-id>
command to set the VLAN ID you created for the port-list to that specific port in the
PVID table.
• Use the
Example:

Figure 133 Tagged VLAN Configuration and Activation Example

ras (config)# vlan 2000
ras (config-vlan)# name up1
ras (config-vlan)# fixed 10-12
ras (config-vlan)# no untagged 10-12
ras (config-vlan)# exit
ras (config)# interface port-channel 10-12
ras (config-interface)# pvid 2000
ras (config-interface)# exit
2 Configure your management VLAN.
• Use the
managing the switch, and the switch will activate the new management VLAN.
• Use the
Example:
218
command to configure or create a VLAN on the switch. The
vlan <vlan-id>
config-vlan
interface port-channel <port-list> command
command when you are finished configuring the VLAN.
exit
command to create a VLAN (VID 3 in this example) for
vlan <vlan-id>
command to disable the new management VLAN.
inactive
mode.Use the
inactive
Chapter 29 IEEE 802.1Q Tagged VLAN Commands
command to
to enter the config-