Example Ftp Commands; Ftp Command Line Procedure - ZyXEL Communications Dimension GS-2024 User Manual

21.7.1.1 Example FTP Commands

This is a sample FTP session showing the transfer of the computer file "firmware.bin" to the
switch.
This is a sample FTP session saving the current configuration to a file called "config.cfg" on
your computer.
If your (T)FTP client does not allow you to have a destination filename different than the
source, you will need to rename them as the switch only recognizes "config" and "ras". Be
sure you keep unaltered copies of both files for later use.
Note: Be sure to upload the correct model firmware as uploading the wrong model
firmware may damage your device.

21.7.2 FTP Command Line Procedure

1 Launch the FTP client on your computer.
2 Enter
open
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is "1234").
5 Enter
bin
6 Use
put
firmware.bin ras
switch and renames it to "ras". Similarly,
configuration file on your computer (config.cfg) to the switch and renames it to "config".
Likewise
your computer and renames it to "config.cfg". See
information on filename conventions.
7 Enter
quit
Chapter 21 Maintenance
ftp> put firmware.bin ras
ftp> get config config.cfg
, followed by a space and the IP address of your switch.
to set transfer mode to binary.
to transfer files from the computer to the switch, for example,
transfers the firmware on your computer (firmware.bin) to the
get config config.cfg
to exit the ftp prompt.
put config.cfg config
transfers the configuration file on the switch to
Table 43 on page 146
GS-2024 User's Guide
put
transfers the
for more
147