28.8.4 gvrp
Syntax:
GVRP (GARP VLAN Registration Protocol) is a registration protocol that defines a way for
switches to register necessary VLAN members on ports across the network. Enable this
function to permit VLANs groups beyond the local switch.
An example is shown next.
• Enable the IEEE 802.1Q tagged VLAN command to configure tagged VLAN for the
switch.
• Enable ports one, three, four and five for configuration.
• Enable GVRP on the interface.
Figure 124 gvrp Command Example
ras(config)# vlan1q gvrp
ras(config)# interface port-channel 1,3-5
ras(config-interface)# gvrp
28.8.5 ingress-check
Syntax:
Enables the device to discard incoming frames for VLANs that are not included in a port
member set.
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Enable ingress checking on the interface.
Figure 125 ingress-check Command Example
ras(config)# interface port-channel 1,3-5
ras(config-interface)# ingress-check
28.8.6 frame-type
Syntax:
Chapter 28 Command Examples
gvrp
ingress-check
frame-type <all|tagged|untagged>
GS-2024 User's Guide
211