Mvr Group Configuration; Figure 37 Advanced Application > Multicast > Multicast Setting > Mvr: Group Configuration - ZyXEL Communications ES-315 - V3.70 User Manual

Table 24 Advanced Application > Multicast > Multicast Setting > MVR (continued)
LABEL
None
Tagging
Add
Cancel
VLAN
Active
Name
Mode
Source Port
Receiver Port
802.1p
Delete
Cancel

13.7 MVR Group Configuration

All source ports and receiver ports belonging to a multicast group can receive multicast data
sent to this multicast group.
Configure MVR IP multicast group address(es) in the Group Configuration screen. Click
Group Configuration in the MVR screen.
Figure 37 Advanced Application > Multicast > Multicast Setting > MVR: Group Configuration
ES-315/ES-315-F User's Guide
DESCRIPTION
Select this option to set the port not to participate in MVR. No MVR multicast traffic
is sent or received on this port.
Select this checkbox if you want the port to tag the VLAN ID in all outgoing frames
transmitted.
Click Add to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to begin configuring this screen afresh.
This field displays the multicast VLAN ID.
This field displays whether the multicast group is enabled or not.
This field displays the descriptive name for this setting.
This field displays the MVR mode.
This field displays the source port number(s).
This field displays the receiver port number(s).
This field displays the priority level.
To delete a multicast VLAN(s), select the rule(s) that you want to remove in the
Delete column, then click the Delete button.
Click Cancel to clear the Delete check boxes.
Chapter 13 Multicast
81