Mvr Configuration Example; Figure 38 Mvr Configuration Example; Table 25 Advanced Application > Multicast > Multicast Setting > Mvr: Group Configuration - ZyXEL Communications ES-315 - V3.70 User Manual

Intelligent layer 2 managed switch
Table of Contents

Advertisement

Chapter 13 Multicast
The following table describes the labels in this screen.
Table 25 Advanced Application > Multicast > Multicast Setting > MVR: Group Configuration
LABEL
Multicast
VLAN ID
Name
Start Address
End Address
Add
Cancel
MVLAN
Name
Start Address
End Address
Delete
Cancel

13.7.1 MVR Configuration Example

The following figure shows a network example where ports 1, 2 and 3 on the Switch belong to
VLAN 1. In addition, port 4 belongs to the multicast group with VID 200 to receive multicast
traffic (the News and Movie channels) from the remote streaming media server, S. Computers
A, B and C in VLAN are able to receive the traffic.

Figure 38 MVR Configuration Example

To configure the MVR settings on the Switch, create a multicast group in the MVR screen and
set the receiver and source ports.
82
DESCRIPTION
Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-
down list box.
Enter a descriptive name for identification purposes.
Enter the starting IP multicast address of the multicast group in dotted decimal
notation.
Refer to
Section 13.1.1 on page 73
Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the Start Address field if you want to configure only one
IP address for a multicast group.
Refer to
Section 13.1.1 on page 73
Click Add to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
This field displays the multicast VLAN ID.
This field displays the descriptive name for this setting.
This field displays the starting IP address of the multicast group.
This field displays the ending IP address of the multicast group.
Select Delete Group and click Delete to remove the selected entry(ies) from the table.
Select Cancel to clear the checkbox(es) in the table.
for more information on IP multicast addresses.
for more information on IP multicast addresses.
ES-315/ES-315-F User's Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Es-315Es-315-f

Table of Contents