ZyXEL Communications ES-315 - V3.70 User Manual page 70

Chapter 11 Bandwidth Control
Table 19 Advanced Application > Bandwidth Control (continued)
LABEL
*
Active
Ingress Rate
Active
Egress Rate
Apply
Cancel
70
DESCRIPTION
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select this check box to activate ingress rate limits on this port.
Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the incoming
traffic flow on a port.
Select this check box to activate egress rate limits on this port.
Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the out-
going traffic flow on a port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to reset the fields.
ES-315/ES-315-F User's Guide