Table of Contents
Advertisement
Chapter 7 VLAN
Figure 24 Advanced Application > VLAN > Static VLAN
The following table describes the related labels in this screen.
Table 14 Advanced Application > VLAN > Static VLAN
LABEL
ACTIVE
Name
VLAN Group ID
Port
*
Control
Tx Tagging
Add
Cancel
Clear
60
DESCRIPTION
Select this check box to activate the VLAN settings.
Enter a descriptive name for the VLAN group for identification purposes. This name
consists of up to 64 printable characters.
Enter the VLAN ID for this static entry; the valid range is between 1 and 4094.
The port number identifies the port you are configuring.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select Normal for the port to not be part of the VLAN group. This is the default
selection. On GVRP-capable devices, the Normal status allows the port to join the
VLAN dynamically. However, the Switch does not support GVRP.
Select Fixed for the port to be a permanent member of this VLAN group.
Select Forbidden if you want to prohibit the port from joining this VLAN group.
Select TX Tagging if you want the port to tag all outgoing frames transmitted with
this VLAN Group ID.
Click Add to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to change the fields back to their last saved values.
Click Clear to start configuring the screen again.
ES-315/ES-315-F User's Guide
Advertisement
Table of Contents
Troubleshooting
