Configuring Queuing; Figure 30 Queuing Method; Table 20 Queuing Method - ZyXEL Communications ES-315 - V3.70 User Manual

Chapter 12 Queuing Method

12.2 Configuring Queuing

Click Advanced Application > Queuing Method in the navigation panel.

Figure 30 Queuing Method

The following table describes the labels in this screen.

Table 20 Queuing Method

LABEL
Port
Method
Q0~Q3 Weight
Apply
Cancel
72
DESCRIPTION
This label shows the port you are configuring.
Select SPQ (Strict Priority Queuing) or WFQ (Weighted Fair Queueing).
Strict Priority Queuing (SPQ) services queues based on priority only. When the
highest priority queue empties, traffic on the next highest-priority queue begins. Q3
has the highest priority and Q0 the lowest.
Weighted Fair Queuing is used to guarantee each queue's minimum bandwidth
based on their bandwidth portion (weight) (the number you configure in the Weight
field). Queues with larger weights get more guaranteed bandwidth than queues with
smaller weights.
When you select WFQ, enter the queue weight here. Bandwidth is divided across
the different traffic queues according to their weights. Queues with larger weights get
more service than queues with smaller weights.
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to begin configuring this screen afresh.
ES-315/ES-315-F User's Guide