Option Settings; Sd Memory Card; Camera Settings - Sanyo VCC-HD2500 Manual

Operation
Restarting camera
Stopping recording/Removing SD
memory card
Resuming stopped
recording/Having camera
recognize SD memory card
Restoring factory default settings
Restoring factory default back
focus position
Resetting login password
(for default users only)
Adjusting focus
Adjusting iris
Viewing Firmware Version
Be sure to stop recording once before attempting to restart the camera or restoring the factory default
settings. Performing these operations during recording prevents correct video recording.
This bracket may be attached to either the top or bottom face of the camera depending on the installation
environment.
For bracket installation, be sure to use the longer screws supplied.
Install the camera securely to a durable location, taking into account the total weight of the camera
mount (commercially available) and the camera.
Associated button and use
Press the RESET button.
Press the NEAR button for 2 seconds or more.
Doing so causes the power indicator to start
blinking and then stay lit when the camera is
ready for you to remove the SD memory card.
Press the FAR button for 2 seconds or more.
The power indicator starts blinking and then
stays lit when the camera has recognized the

SD memory card.

Press the NEAR and SET buttons
simultaneously.
Press the NEAR and FAR buttons
simultaneously.
Press the FAR and SET buttons
simultaneously.
For details, refer to the "Lens Adjustment"
section.
For details, refer to the "Viewing Firmware
Version" section.
Equivalent network
operation screen

OPTION SETTINGS

(CAMERA REBOOT)
SD MEMORY CARD
(SD MEMORY CARD)
OPTION SETTINGS
(FACTORY DEFAULT)

CAMERA SETTINGS

(FOCUS ASSIST)
Not supported via
network operation
CAMERA SETTINGS
(FOCUS ASSIST/IRIS
SETTINGS)
OPTION SETTINGS
(FIRMWARE UPDATE)
Introduction 8/18