Sanyo VCC-HD2500 Manual page 125

A
Disabling motion detection in masked areas
B
Detecting motion in specific areas
C Detecting motion with lines and areas drawn on the screen
In [MOTION], after selecting a motion sensor type, click
detailed configuration screen.
You can configure the camera to "automatically output alarm signals" or "remotely (manually) output alarm
signals".
You can configure the camera to automatically output an alarm signal when either of its alarm input terminals
receives an alarm signal.
Setting Item
ALARM OUT1/ 2 (Alarm
output terminal number)
POLARITY (Signal polarity)
ALARM OUT TIME (Alarm
output time)
ALARM IN (Output
condition)
MOTION (Output condition)
Use the Remote Alarm buttons (
alarm output terminals.
Default Setting
OFF (Disables alarm output.)
NO
5SEC (Ex.: Beeps a warning for 5 sec.)
ALARM IN1 (Triggers alarm output when
ALARM IN1 terminal receives an alarm
signal.)
OFF (Disables alarm output using motion
sensor.)
) provided on the live screen to send alarm signals from the camera's
DETAIL to configure the detection conditions on the
ON (Enables automatic alarm output.)
NC
10SEC to 5MIN
ALARM IN2 (Triggers alarm output when
ALARM IN2 terminal receives an alarm
signal.)
ON (Triggers alarm output using motion
sensor.)
Optional Setting
Quick Operation Guide 7/13