Sanyo VCC-HD2500 Manual page 127

After installing an SD memory card into the camera, you need to configure the alarm recording settings as
described below.
You can store the following data on an SD memory card. However, you cannot use SD memory
cards to record normal surveillance video that is not alarm video.
Alarm video recording
Backup video recording in event of a network failure
Access and system logs
1
Click in the configuration menu.
SD
On the SD MEMORY CARD screen, format the SD memory card as required.
Setting Item
1
SD MEMORY NO USE
CARD
2
AREA ALARM (Alarm/backup recording storage
area): 100
LOG (Log information storage area): 0
3
SIZE/FORMAT Displays the storage capacity of SD
memory card
When finished formatting the SD memory card, close the SD MEMORY CARD screen.
2
Click RECORDING
On the RECORDING screen, configure the recording settings as follows.
Setting Item
1
RECORD STREAM
2
ALARM EVENT1
3
TRIGGER (Recording
trigger conditions)
4
PRE ALARM
When finished configuring the above basic recording settings, configure the recording schedule as required.
Default Setting
in the configuration menu.
Default Setting
OFF
OFF
ALARM IN1 (Triggers recording when
ALARM IN1 terminal receives an alarm
signal.)
OFF
Required Setting/Operation
USE (Records data onto SD memory card.)
To secure a log information storage area, change the
[LOG] value.
Check the storage capacity and click
Required Setting
Select the desired stream (STREAM1 to
STREAM4).
ON
You can configure three patterns of recording
conditions (for ALARM EVENT1 to 3).
ALARM IN2, MOTION, ALARM OUT1/2,
NETWORK FAILURE
ON (Records video for a specific period
before alarm occurrence.)
Quick Operation Guide 9/13
FORMAT
.