Sanyo VCC-HD2500 Manual page 54

Clicking [FOCUS ASSIST] in the configuration menu displays the [FOCUS ASSIST] screen.
If you have already completed focus adjustment on the camera, you do not need to follow the adjustment
procedures described here.
You may also configure the back focus position switching mode as required to automatically adjust the back focus
position when switching between the color and black-and-white video modes.
The configured settings will be applied commonly to "CAM1" and "CAM2" selected under [VIEW].
You can fine-adjust the focus from the configuration menu.
It is recommended to roughly adjust the focus using the lens levers and the buttons provided on the left-side face
of the camera during installation.
The focus must be readjusted if the camera has lost focus due to difference in the subject distance or
ambient temperature, the deterioration of the lens and installation environment, and the like that have
been caused over the years.
1
Select the [MANUAL] check box.
You can now operate the
2
Click to focus on the subject.
ONE PUSH
The camera automatically focuses on the subject. Note that the color of the status indicator (
turns from black to orange.
If the camera fails to focus on the subject, the status indicator (
adjust the focus (in Step
3
Click NEAR / FAR
The back focus position has been changed.
To restore the default back focus position during re-adjustment etc., click
While the camera is initializing the back focus position, the status indicator (
"INITIALIZING".
NEAR FAR DEFAULT
, ,
3
).
to focus on the subject.
ONE PUSH
, and buttons.
A ) will show "ERROR". In this case, manually
Working with Administrator Configuration Screens 34/66
A ) "FOCUSING"
DEFAULT
.
A ) shows