Choice Of Contact Points; Fitting On The Training Collar - Dog trace d-control Edge ONE Manual

the collar.
2. Place the red mark on the bottom of the transmitter against the red mark on the receiver
for 5 seconds (similar to switching on the receiver - as shown in chapter 7.3). The green
indication light will come on, followed by the red indication light.
3. After 5 seconds, the green and red indication lights will flash alternately.
4. Press the button on the transmitter.
WARNING: In case you do the collar pairing according to chapter 7.4 - the collar is turned
off before the pairing starts, the paired second transmitter is automatically deleted from
the collar.
TIP: 2 positions on one transmitter can be paired to one collar according to the procedure
in chapter 7.5. This feature can be used to call multiple dogs iwith one command at the
same time - for example, I have 5 dogs paired to positions 1 to 5. On position 6 I can pair
all 5 dogs according to the procedure in chapter 7.5 and thus I can call all dogs at the
same time by pressing one button.

7.6 Choice of contact points

To ensure the transmission of stimulation impulses from the receiver to the dog's skin,
stainless contact points are used. Each package contains two types. If your dog has short
hairs, use the short contact points. If you have a dog with longer or thicker hairs, choose the
longer contact points. Screw the contact points onto the receiver - see Figure 3/3 on page 2.
Tighten the contact points by hand. Do not use pliers or other tools to tighten, you may cause
irreparable damage to the product.
TIP: If your dog's hairs is too long, it is possible to use contact points with a length of
12/17/21 mm. If the dog has dry skin, it is option to lubricate the skin where the contact
points touch the skin, with medical vaseline, moisturizing oil, etc. This will ensure better
transmission of the stimulation impulses.

7.7 Fitting on the training collar

The strap (collar) on which the receiver is attached must be tightened to ensure good contact
between the contact points of the receiver and the dog's skin. It is recommended to put
the collar on when the dog is in standing position. The collar with the receiver is properly
tightened if you can put 2 fingers between the collar and the dog's neck. If the dog has long
or thick hair, it is advisable to cut the hair where the contact points touch the skin or choose
a longer type of contact points.
WARNING: If the collar is too loose, the receiver is likely to
move and repeated rubbing may irritate your dog's skin.
even more, reliable contact of the contact points with the
skin surface is not assured and thus proper function of
the training collar is not assured. We do not recommend
leaving the collar on you dog for several hours in the same
place, as it could cause skin irritation. If your dog needs
to wear the collar for long periods of time, change the
position of the receiver on the neck regularly. A collar with
a receiver that is overtightened can cause blisters on the
skin where the contact points touch. If this happens, do
not use the training collar until all signs of irritation have
disappeared.
EN
31