To Change Parameters - Roland V-Mixer VM-C7100 Quick Start Manual

To Change Parameters

To change the value of a parameter, move the cursor to select a parameter,
and use the knobs [V1]-[V6], faders, and/or buttons [F1]-[F6] to change its
value, as described below.
To Move the Cursor
The cursor – a bold rectangle on the display – selects a single parameter or
group of parameters so that their values can be adjusted. To move the
cursor, press CURSOR [UP] [DOWN] [LEFT] [RIGHT].
To Set the Values of Parameters
There are certain rules for setting parameters, as listed below. We
recommend you keep them in mind.
• parameters are set by turning knobs [V1]-[V6]. Turn the knob
below the parameter you wish to change.
• parameters are set by pressing buttons [F1]-[F6]. Press the
button for ON – this highlights the parameter in black on the display
– or OFF (not highlighted) below the parameter you wish to change.
ON
• parameters are set by turning knobs [V1]-[V6] first, and then
pressing buttons [F1]-[F6](SET) to confirm the changes. Use the knob
and button below the parameter you wish to change. (Some
parameters can be set by pressing [F1]-[F6](SET) only.)
• Parameters shown as faders are set using the console's faders. If the
fader indicated is selected by the cursor, you can also change its
value by turning the corresponding knobs [V1]-[V6].
To Operate on [INPUT] or [MULTI IN] channels
To set the input source's gain level and the tone, such as using the equalizer
and so on, press [INPUT] or [MULTI IN] to select the type of channel you
wish to setup.
With the selected button lit in red, you can control the behavior of each
source signal using the console's faders or display controls.
OFF
Before Mixing Operations
The cursor does not appear
on a display where no
cursor selection is needed.
If you want to display or
change frequently used
parameters, or the value of
a single parameter on all of
the channels at once, you
can do this more easily by
using the console's faders
(Owner's Manual "Useful
Functions" p.58).
25