Roland V-Mixer VM-C7100 Quick Start Manual page 83

1
Make your connections as shown on the left.
• Place monitor amplifier speakers on the stage and connect them to
FLEX BUS OUTs 11 and 12 (for a single stereo monitor feed).
• Route any electric guitar or instrument with pickups through direct
boxes or a compact effect processor connected to the system input.
2
Turn on the power of devices in the following sequence.
1. Digital multi-track recorder
2. Digital devices (CD player, etc.)
3. Analog devices (instruments, microphones, electric guitars, etc.)
4. Mixing processor
5. Mixing console
6. Audio equipment (amplifiers, speakers)
3
Select the EZ Routing template for 8 Track Recording of a Live
Jazz Ensemble.
1. Press [EZ ROUTING], and then press [F1](TEMPLATE)
2. Turn [V1](SELECT GROUP) to select group "P", and then turn
[V2](SELECT NUMBER) to select "P004: Live Jazz".
3. Press [F2](CP/LOAD).
• The "Live Jazz" template has been recalled.
4
Set the input gain of each signal on the console.
1. Press [INPUT].
2. Press [PREAMP GAIN].
3. Use the faders to adjust the input gain level of each source.
• If you are using any condenser microphones, activate their
PHANTOM power.
5
Adjust each EQ as necessary.
1. Press [CH EDIT] on the desired channel.
2. Press [PAGE UP] [PAGE DOWN] to select the "EQ BAND" page.
3.Use CURSOR [UP] [DOWN], [V1]-[V6] and [F1]-[F6] to set the EQ.
Using EZ Routing Templates
QUICK START "Turning
On the Power" (p.10)
Owner's Manual "Calling
Up Stored Connections (EZ
Routing)" (p.59)
Owner's Manual "Gain,
Phantom Power Supply,
Phase and Attenuator"
(p.68)
Owner's Manual
"Adjusting Various
Channel Settings
(Equalizer, etc.)" (p.78)
83