Roland V-Mixer VM-C7100 Quick Start Manual page 55

2
Press CURSOR [UP] [DOWN] to select the FX field.
FX-1-3 are located in the upper field, FX-4-6 in the middle, and FX-7-8 in the
lower ("MST FX MENU" does not call for this step).
If you do not have an optional VS8F-2 installed, you can only select FX-1 or
FX-2.
3
Press [F2], [F4], [F6], or [F2] on "MST FX MENU" to "EDIT".
The "EFFECT (1-8)" or "MASTER FX" display appears.
4
Press [PAGE DOWN] to go to the "ASSIGN" page.
At this point, you set the insertion point of the effect.
fig.216
Flex Bus channel to which an effect is inserted.
Flex Bus channel to which an effect is not inserted.
5
Press CURSOR [UP] [DOWN] to select L or R.
("MST FX MENU" does not call for this step.)
6
Turn [V4](SEND LEVEL) to adjust the level to be sent into the
effect, and [V5](RETURN LEVEL) to adjust the effect's output
level.
The setting's range is 0 to 127, with no boost or cut applied to the gain (0dB)
at 100.
Using On-Board Effects
55