To Install A Hard Disk Cage; Installing A Hard Disk Cage In A Bcm400 Main Unit - Nortel BCM200 Installation And Maintenance Manual

Figure 126 Insert the hard disk cage into the BCM200 main unit
Slide the hard disk cage
toward the front of the
main unit.
7 Replace the cover (if applicable) and access panel.
8 Restore the BCM system to operation. Refer to
page 234.
9 If you installed a new programmed hard disk in a standard configuration (for RAID
configuration, skip to the next step):
a
Initialize the hard disk. Refer to
on page
b After the disk is initialized, restore your data from your backups. If you did not back up
your keycodes, reenter them (see
10 If you installed a new blank hard disk (mirror or primary) in a RAID, wait for the disk mirror
process to complete. For further information on how to monitor disk mirroring progress, refer
to "RAID disk mirroring" on page

Installing a hard disk cage in a BCM400 main unit

Use this procedure to install the standard or RAID configuration hard disk cage into the BCM400
advanced function tray.
Warning: Protect the hardware components against damage from electrostatic discharge.
Always wear a grounded wriststrap before you handle components. Always place the
components in a static-free container.

To install a hard disk cage

1 Disconnect the BCM system from the AC power source.
2 Attach one end of the grounding strap to your wrist and the other end to a grounded metal
surface.
275.
224.
Chapter 22 Replacing the hard disk
"Restarting the system after maintenance" on
"Initializing the hard disk in a single-disk configuration"
"Software keycode" on page
BCM200/400 4.0 Installation and Maintenance Guide
183).
265