To Install A Mirror Hard Disk Into A Raid Hard Disk Cage - Nortel BCM200 Installation And Maintenance Manual

274 Chapter 22 Replacing the hard disk
Note: The hard disk storage capacity (in MB) for both hard disks must be identical.
Equipment provided by Nortel assures correct hard disk capacity requirements.

To install a mirror hard disk into a RAID hard disk cage

1 Install the mirror hard disk into the bottom position of the RAID hard disk cage.
2 Align the hard disk and hard disk cage retaining screw holes. Fasten the hard disk cage retainer
screws into both sides of the hard disk cage (see
Figure 133 Install a mirror hard disk into the RAID hard disk cage
Install the mirror hard disk into the bottom
1
position of the hard disk cage
3
Install and connect the mirror hard disk IDE ribbon cable to the mirror hard disk and RAID
card. Retain the folds in the mirror hard disk IDE ribbon cable. Ensure you connect the mirror
hard disk to the correct RAID IDE connector.
4
If you removed the primary disk, see
cage" on page
card. Retain the folds in the primary hard disk IDE ribbon cable. Ensure you connect the
primary hard disk to the correct RAID IDE connector.
Caution: It is vital that you connect the correct IDE ribbon cables to the correct hard
disks. Connect the primary ribbon cable to the primary hard disk. Connect the mirror
ribbon cable to the mirror hard disk
N0060612 N0060612
BCM400 RAID shown
271. Install and connect the primary hard disk IDE ribbon cable to the RAID
Figure 133).
Install the mirror hard disk retainer screws
2
Install and connect the mirror hard disk IDE
3
ribbon cable to the mirror hard disk and RAID
card.
"Installing a primary hard disk into a RAID hard disk