To Remove The Advanced Function Tray - Nortel BCM200 Installation And Maintenance Manual

Advanced
Figure 112
If possible,
do a system
shutdown
Perform BCM
maintenance
setup
Remove the
advanced function
tray
Remove hard
disk
Install new hard
disk

To remove the advanced function tray

Warning: Use care when removing or inserting the advanced function tray. Do not
forcefully remove or insert the advanced function tray because you could damage or
stretch the cables.
Warning: Protect the hardware components against damage from electrostatic discharge.
Always wear a grounded wrist strap before you handle components. Always place the
components in a static-free container or work area.
1 Shut down the system (see
2 Disconnect the BCM system from the AC power outlet.
3
Remove the main unit top cover (see
Return to this step when complete.
4 Attach one end of the grounding strap to your wrist and the other end to a grounded metal
surface.
5 Remove the advanced function tray latch screws (see
location.
6 Move the advanced function tray latches to the unlocked position.
Chapter 20 Preparing hardware for maintenance or upgrades
function tray replacement overview
Insert the
advanced function
tray
Restore unit to
operation
Check LEDs
END
"Performing a system shutdown" on page
"Removing the main unit top cover" on page
Figure
BCM200/400 4.0 Installation and Maintenance Guide
233).
246).
113). Place the screws in a safe
243