NetComm N3G001W User Manual page 29

3g wireless router

Hide thumbs Also See for N3G001W:

Table of Contents

To Configure WDS click on WDS Setting button and you will be presented with the following page.

WDS is used to wirelessly connect multiple Access Points (in WDS mode), and in doing so extend the wireless

infrastructure to locations where cabling is not possible or inefficient to implement.

Notes: Be sure you understand the purpose of WDS mode before continuing with the configuration. And not all Access Point can be use

in WDS mode.

To enable WDS please make sure to tick the Enable tick box for Wireless Bridging.

And then type in the MAC address of the remote WDS unit in the Remote AP MAC list. Or you can copy the

one from the Scanned AP's MAC list. This router can accommodate up to 6 remote MAC addresses.

Click Save to save the settings and Undo to cancel.

YML869 Rev1

www.netcomm.com.au

N3G001W 3G Wireless Router User Guide

Table of Contents