NetComm N3G001W User Manual page 14

Windows 95, 98 PCs
First, check for the IP protocol and, if necessary, install it:
1. In the Windows task bar, click the Start button, point to Settings, and then click Control Panel.
2. Double-click the Network icon.
The Network dialog box displays with a list of currently installed network components. If the list includes
3.
TCP/IP, and then the protocol has already been enabled. Skip to step 9.
4. If TCP/IP does not display as an installed component, click Add... The Select Network Component Type
dialog box displays.
5. Select Protocol, and then click Add... The Select Network Protocol dialog box displays.
6. Click on Microsoft in the Manufacturers list box, and then click TCP/IP in the Network Protocols list box.
7. Click OK to return to the Network dialog box, and then click OK again. You may be prompted to install
files from your Windows 95/98 installation CD.Follow the instructions to install the files.
8. Click OK to restart the PC and complete the TCP/IP installation.
Next, configure the PCs to accept IP information assigned by the Modem:
9. Follow steps 1 - 3 above.
Select the network component labeled TCP/IP, and then click Properties. If you have multiple TCP/IP
10.
listings, select the listing associated with your network card or adapter.
11. In the TCP/IP Properties dialog box, click the IP Address tab.
12. Click the radio button labeled Obtain an IP address automatically.
13. Click OK twice to confirm and save your changes. You will be prompted to restart Windows.
14. Click Yes.
N3G001W 3G Wireless Router User Guide
1
YML869 Rev1
www.netcomm.com.au