Kaye Validator AVS User Manual page 159

Group (Max of Max)- (Min of Min): The Grp. (Max of Max) – (Min of Min) calculates
the maximum value for all sensors in a group and all timestamps, minus the minimum
value for all sensors in the group for all timestamps in the cycle. The criteria define the
maximum allowable difference between the (Max of the Max) and the (Min of the Min)
for the Cycle. The criterion "Passes" if the calculated value is equal to or less than the
defined criteria.
Accumulated Lethality for (Exposure) Cycle: The Accumulated Lethality / Exposure
Cycle criteria is only selectable if the lethality condition is defined and included in the
Setup or edited in the edit calculations tile. The calculated lethality value applies only to
the selected cycle. The calculated value is the minimum Accumulated Lethality for all
sensors in the group. The criteria define the Minimum Accumulated Lethality that must
be reached by all sensors in the Group. The criterion "Passes" if the calculated value is
equal to or greater than the defined criteria.
Accumulated Lethality as in "Edit calculations": The Accumulated Lethality as in
Edit Calculations criteria is selectable if the lethality condition is defined and included in
the Setup or edited in the edit calculations tile. The calculated lethality value does not
apply to the selected cycle, but rather to the Calculate Lethality field in the "Edit
Calculations" tile. The calculated value is the minimum Accumulated Lethality for all
sensors in a group. The criteria define the Minimum Accumulated Lethality that must
be reached by all sensors in the Group. The criterion "Passes" if the calculated value is
equal to or greater than the defined criteria.
Note: This is the only criterion that does not use the cycle defined in the criteria
template, but the definition of the lethality calculation set in the Edit Calculations
screen.
Only lethality per cycle or per Edit Calculations can be calculated within the
same report. The selection of one automatically deselects the other one.
T-SAT T / Timestamp - Temperature - Saturation Temp Band per Timestamp:
Steam quality is analyzed by comparing the measured process temperature value
against the calculated Saturation Temperature derived from pressure measurements
for every timestamp. The pressure sensor used as the reference is displayed. The
criterion describes a steam quality band and is specified as the Min and Max allowable
deviation from the measured temperature to the calculated Saturation temperature.
The criterion "Passes" if all values are equal to or within the defined range.
Kaye Validator AVS User Manual
Chapter 11: Qualification Reports
148