Kaye Validator AVS User Manual page 146

Statistical
Dependent on Sensor Group selection, the following Statistical calculation graphs
are available Max Value, Min Value, Avg Value, Avg and Std Dev, Max-Min, Max-
Avg, and Avg-Min.
Lethality
The Accumulated Lethality graph displays lethality totals for each included sensor
at each timestamp programmed or defined to calculate lethality. Alternatively, the
lethality accumulation can also be displayed as a bar graph.
Sat P
The Saturation Pressure calculation is only available if the study includes at least
one temperature sensor and pressure sensors.
The Saturation Pressure vs. Measured Pressure graph displays measured
pressure from the selected pressure sensor and the saturation pressure
calculated from the temperature sensors selected in the Edit Sensors screen. To
access the Saturation Pressure vs. Measured Pressure graph, select Temp and
Pressure Sensors group from Select Group dropdown list.
Sat T
The Saturation Temperature calculation is only available if the study includes at
least one pressure sensor along with temperature sensors.
The Saturation Temperature vs. Measured Temperature graph displays the
saturation temperature calculated from the selected pressure sensor and the
measured temperature from the sensors selected in the Edit Sensors screen. Red
horizontal lines on the graph display the base temperature (Tb) entered during the
study setup, and the base temperature +3 K. The text at the bottom of the graph
displays if the data passed or failed three conditions:

All measured temperatures and the calculated saturation temperature
are within the specified sterilization temperature band.

Each measured temperature and the calculated saturation temperature
do not fluctuate more than 1 K.

All measured temperatures and the calculated saturation temperature do
not differ from each other by more than 2 K.
Kaye Validator AVS User Manual
Chapter 11: Qualification Reports
135