Table of Contents
Advertisement
●
Auto Turn Off the Backlight – Tap Start > Settings > System > Backlight. Specify a short
amount of wait time before turning off the backlight. On the Battery Power tab, set Turn off
backlight if device is not used for to 10 seconds.
●
Use the Power Save Mode – The Power Save Mode conserves battery, especially when your
battery power is low. For more information, see
●
Use the Light Sensor – Use the light sensor feature to automatically adjust the backlight
brightness and conserve the battery. For more information, see
on page
To check the battery power, tap Start > Settings > System > Power, or tap the
Today screen.
NOTE:
In case of a battery drain out, you lose any data that has not been saved on your HP iPAQ.
HP advises you to keep your HP iPAQ fully charged at all times.
WARNING!
HP iPAQ.
Power Save Mode
Activating the Power Save Mode helps conserve your HP iPAQ battery power until the next charging
cycle. The Power Save Mode will become active when the battery reaches 25% of the full charge level
and a warning is displayed on the screen. If you cancel this warning, another warning is displayed when
the battery drains to 10% of the full charge level and the device goes into the Power Save Mode.
When the device is in the Power Save Mode,
screen. Power Save Mode will automatically turn off after charging your battery above the 25% level,
and all the adjusted system settings are restored.
To turn on Power Save Mode:
1.
Tap Start > Settings > System > Power Save Mode.
2.
Set the Power Save Mode option to On.
3.
Tap ok.
To configure Power Save Mode settings:
1.
Tap Start > Settings > System > Power Save Mode.
2.
Select the required settings and tap ok.
TIP:
You can also tap Advanced to adjust advanced settings for the Power Save Mode.
To turn off Power Save Mode:
1.
Tap Start > Settings > System > Power Save Mode.
2.
Set the Power Save Mode option to Off.
3.
Tap ok.
NOTE:
when it is in Power Save Mode.
28
Chapter 5 Get started with your HP iPAQ
23.
Removing the battery from your HP iPAQ before turning it off might corrupt data on your
Another way to exit Power Save Mode is to follow the alert messages on your HP iPAQ
Power Save Mode on page
Adjust the brightness settings
(Power Save Mode icon) is displayed at the top of the
28.
(Battery) icon on the
Advertisement
Table of Contents
