Step 4: Turn On Your Hp Ipaq; Step 5: Locate The Stylus - HP iPAQ Data Messenger Product Manual

3. Connect the other end of the cable to the Micro-USB connector port on your HP iPAQ. The cable
connector only fits one way. If the connector does not insert easily, turn it over.
TIP: Charge the battery by connecting your HP iPAQ to a USB port on your computer through
the Micro-USB synchronization cable. The Microsoft
the screen if you connect your HP iPAQ to a computer that has the software already installed on
the computer.
To enable USB charging on your HP iPAQ, tap Start > Settings > System > Power > USB
Charging. On the Power screen, select the Use USB Charging check box, select the Fast
Charging option, and then tap ok.

Step 4: Turn on your HP iPAQ

Press and hold the
instructions on the screen to complete the setup. Tap the keyboard icon on the screen to use the
on-screen keyboard. Alternatively, you can use the keyboard to specify information. To learn more about
keyboard use, see
NOTE: The HP iPAQ will take a few minutes to become fully functional. The keyboard will not be active
during this period.

Step 5: Locate the stylus

You can use the stylus to tap and enter text using the on-screen keyboard. You can also use the stylus
to tap and select items on the screen.
To remove the stylus:
1. Locate the stylus on the back of your HP iPAQ.
10 Chapter 4 Set up your HP iPAQ
(End/Power) key for five seconds to turn on your HP iPAQ. Follow the
Step 6: Use the keyboard on page
® ActiveSync ® or WMDC program appears on
11.