The Hp Summary Screen And Setup Program; Viewing The Hp Summary Screen; Starting The Hp Setup Program - HP Kayak XU User Manual

4 Technical Information

The HP Summary Screen and Setup Program

The HP Summary Screen and Setup Program
This section introduces the HP Summary Screen and the HP Setup
program. You can use the Summary Screen and the Setup program to
configure your PC Workstation and solve configuration problems with
your PC Workstation.

Viewing the HP Summary Screen

Check your PC Workstation's configuration when you first use the PC
Workstation and each time after you install, remove, or upgrade
accessories. To check the configuration:
1 Turn on the display and then the PC Workstation. If the PC
Workstation is already turned on, save your data and exit all
programs, then restart the PC Workstation. Consult your operating
system documentation for any special instructions concerning
turning off and then restarting your PC Workstation.
2 While the startup logo appears on your display, press
you to the HP Summary Screen. (To go immediately into the Setup
program, and bypass the Summary Screen, press
). The Summary Screen is displayed for only a short time. To
retain the screen (until you decide to leave it), press

Starting the HP Setup Program

1 Turn on the display and then the computer. If the PC Workstation is
already turned on, save your data and exit all programs, then restart
the PC Workstation. Consult your operating system documentation
for any special instructions concerning turning off and then
restarting your PC Workstation.
2 Press while
If you fail to press
you will need to restart your PC Workstation to go through the POST
again so you can press
3 The opening screen of the PC Workstation's Setup program is
displayed, similar to the one on the next page. Note that the Main
menu selection is highlighted.
92 English
is displayed at the bottom of the screen.
Setup
in time and the start-up process continues,
.
. This takes
instead of
.