If You Can't Start The Setup Program; If The Date And Time Are Incorrect - HP Kayak XU User Manual

3 Troubleshooting Your PC Workstation
If Your PC Workstation Has a Software Problem

If You Can't Start the Setup Program

This may happen if the copy of the PC Workstation's configuration
stored in memory is corrupted. You will need to erase this bad
configuration.
To clear the configuration:
1 Switch off the PC Workstation and remove the cover (see page 23).
2 Set the system board switch 6 (CONFG) on the switch block DOWN
to clear the configuration (refer to page 90 for the switch location).
3 Replace the cover and switch on the PC Workstation to erase the
memory.
4 Check that error codes
the PC Workstation has started.
5 Switch off the PC Workstation and remove the cover.
6 Set the system board switch 6 (CONFG) on the switch block to OFF
to re-enable the configuration.
7 Replace the cover (refer to chapter 2).
8 Switch on the PC Workstation and run Setup by pressing
appears. (Error code
Setup
PC Workstation starts.)
9 Press to save the configuration and exit from Setup.

If the Date and Time Are Incorrect

The date and time can be incorrect because the time changed at the
beginning or end of summer time, or because the PC Workstation has
been unplugged from the power too long, and the Gold Capacitor which
supplies power to the CMOS memory has discharged. To recharge the
Gold Capacitor, plug the PC Workstation into the power for one hour
(there is no need to start the PC Workstation).
You can install an external battery that will keep track of the date and
time if the PC Workstation is unplugged for more than one week (the
external battery connector is shown on page 87; the instructions are
provided on page 70). Contact your HP dealer for complete information
about installing an external battery.
Use the Setup program to change the date and time.
68 English
and are displayed, and wait until
0240 0130
will appear when the
0130
when