HP Kayak XU User Manual page 76

If the Hard Disk Does
Not Work
If the Hard Disk Activity
Light Does Not Work
3 Troubleshooting Your PC Workstation
If Your PC Workstation Has a Hardware Problem
device priority list)
Write on flexible disk drives (select the Security menu and the
•
Hardware protection submenu and check that Write on Flexible
Disks is
Unlocked
Check that the disk power and data cables are correctly connected.
•
Check that the disk power and data cables are correctly connected
•
(refer to Connecting Devices on page 32).
Check that the hard disk drive has been
•
program, select the Security menu and refer to the Hardware
Protection submenu). There is also an option in the Setup program
that lets you enable or disable boot on the hard disk drive (refer to
the Boot Devices Security submenu of the Security menu and check
that Start from IDE HDD is
Check that all hard disk drives have been detected (in the
•
SCSISelect™ utility, select SCSI Disk Utilities and check that each
hard disk drive is listed with a SCSI ID).
If you have installed an IDE hard disk and are using the integrated
•
IDE controller, check that the Local Bus IDE is enabled (in the Setup
program, select the Advanced menu, the IDE Devices submenu, and
check that Local Bus IDE adapter is
If you have installed the Adaptec
In the SCSISelect utility, check that each disk drive has a unique
•
SCSI ID.
Run the ArrayConfig™ utility to check the array configuration.
•
Use the ArrayConfig utility (and not HP Setup) to check that the
•
array has been selected as the boot device.
For further details and troubleshooting advice, refer to "The HP
FastRAID Option" on page 84.
If the hard disk activity light does not flicker when the PC Workstation
is accessing the hard disk drive:
Check that the control panel connector is firmly attached to the
•
system board.
Check that the disk power and data cables are correctly connected.
•
64 English
).
Unlocked
).
Enabled
Primary
®
RAIDport adapter:
(in the Setup
).