Troubleshooting Your HP Visualize Personal Workstation
The HP Summary Screen and Setup Program
You can use the Summary Screen and the Setup program to configure
your Personal Workstation and solve configuration problems with your
Personal Workstation.
Starting the HP Setup Program
1. Turn on the display and then the Personal Workstation. If the
Personal Workstation is already turned on, save your data and exit
all programs, then restart the Personal Workstation. Consult your
operating system documentation for any special instructions
concerning
turning
Workstation.
2. Press
while
If you fail to press
will need to restart your Personal Workstation to go through the
POST again so you can press
The opening screen of the Personal Workstation's Setup program is
displayed.
Viewing the HP Summary Screen
Check your Personal Workstation's configuration each time after you
install, remove, or upgrade accessories. To check the configuration:
1. Turn on the display and then the Personal Workstation. If the
Personal Workstation is already turned on, save your data and exit
all programs, then restart the Personal Workstation. Consult your
operating system documentation for any special instructions
concerning
turning
Workstation.
2. While the start-up logo appears on your display, press
you to the HP Summary Screen. (To go immediately into the Setup
program, and bypass the Summary Screen, press
The Summary Screen is displayed for only a short time. To retain the
screen (until you decide to leave it), press
Chapter 3
The HP Summary Screen and Setup Program
off
and
then
Setup is displayed at the bottom of the screen.
in time and the start-up process continues, you
.
off
and
then
restarting
your
Personal
restarting
your
Personal
. This takes
instead of
.
).
57