HP Kayak XU User Manual page 39

4 Press the retaining buttons on each side of the HP UltraFlow airflow
guide and lift it out of the PC Workstation's case.
5 Remove the Ultra wide 16-bit SCSI cable from the system board and
then from the (one or two) hard disk drives.
6 Remove the transparent airflow guide covering the processor
sockets (if needed).
7 Remove the floppy disk drive data cable from the system board.
8 The location of the memory module slots is shown here.
2 How to Install Accessories Inside Your PC Workstation
Installing Memory
English 27