HP Kayak XU User Manual page 69

Clearing the
PC Workstation's
Configuration Memory
Press to see more details about the message. After viewing
•
these details, you will be returned to the original POST display
screen. If the message is actually a change to the configuration you
have made (for example, you have just removed some memory), you
can then press
configuration information. Otherwise, press
message and continue, or press
system configuration error. (The number of choices you will have
available are dependent on the kind of error.)
If the PC Workstation then starts, but POST still persists in reporting an
error, clear the current configuration memory values and reinstall the
built-in default values:
1 Turn off the PC Workstation, disconnect the power and cables, and
remove the cover. Disconnect the PC Workstation from any
telecommunications network.
a Set the system board switch 6 (CONFG) DOWN to clear the
configuration.
b Replace the cover, and reconnect only the power cable.
c Turn on the PC Workstation. This will erase the CMOS memory.
d Wait until the PC Workstation has started. A message will be
displayed similar to this:
"Configuration has been cleared, set switch Clear
CMOS to the open position before rebooting."
e Turn off the PC Workstation, disconnect the power cable, and
remove the cover.
f Set the system board switch 6 (CONFG) UP to retain the
configuration.
2 Replace the cover, and reconnect the power and cables.
3 Switch on the PC Workstation. An error message will be displayed
similar to this:
"Incorrect PC Configuration"
The PC Workstation will stop. Press
errors) and then press CTRL-ALT-DEL to reboot.
4 Run Setup by pressing
automatically downloaded and saved.
5 Make any other changes you want and press
configuration and exit from Setup.
3 Troubleshooting Your PC Workstation
If Your PC Workstation Does Not Start Properly
to accept the change and update Setup's
to run Setup and correct a
. CMOS default values will be
to ignore the
(to view the system
to save the
English 57