Installing Accessory Boards; Installing The Board - HP Kayak XA-s02 User Manual

geron.bk : geron-2.fb4 Page 42 Friday, April 24, 1998 5:30 PM
CAUTION
NOTE
2 How to Install Accessories In Your HP Kayak PC Workstation

Installing Accessory Boards

Installing Accessory Boards
Static electricity can damage electronic components. Turn OFF all
equipment. Don't let your clothes touch the accessory. To equalize the
static electricity, rest the accessory bag on top of the computer while
you are removing the accessory from the bag. Handle the accessory as
little as possible and with care.
The PC Workstation has the following accessory board slots (from left
to right):
Slot AT 2 for full-length 16-bit ISA boards
•
Slot AT 1/PCI 4 for either a 16-bit ISA board or a full-length 32-bit
•
PCI board
Slot PCI 3 for a full-length 32-bit PCI board
•
Slot PCI 2 for a full-length 32-bit PCI board
•
Slot PCI 1 for a full-length 32-bit PCI board
•
Slot AGP for the video adapter board.
•

Installing the Board

PCI boards are configured automatically when installed in the
PC Workstation.
1 Disconnect the computer's power cord and any LAN connection or
telecommunications cable.
2 Remove the computer's cover (refer to page 23).
3 Find an empty accessory board slot. Refer to "System Board
Connectors" on page 86 to identify the location of the slot type you
want to use (ISA or PCI).
Some boards may have preferred locations and special installation
instructions detailed in their manuals.
42 English