HP b2600 Supplementary Manual page 83

Insert the two connectors for the power supply cables into their keyed connectors on the system
4.
board. See Figure B-9.
Figure B-9 Connect the Power Supply Cables
Power Supply
Cables
System Board
Connect the power source cables onto their connectors on the back of the workstation's power
5.
supply. Please pay attention to the WARNING in the section "DC Power Supply Considerations"
found in this appendix. See Figure B-10
Figure B-10 Disconnecting the DC Power Source
Appendix B
Replacing the DC Power Supply
Component Heat Sink
Power Source Cables
DC Power Supply
Power Supply
83