HP b2600 Supplementary Manual page 35

5. Replace the PCI cage cover by inserting its two retainer tabs into the retainer slots and
rotating the cover downward until the cover's slide lock snaps into place in the PCI
cage's slide lock slot. See Figure 1-35.
Figure 1-35. Replacing the PCI Cage Cover
Retainer Tabs
and Slots
PCI Cage Replacement
To replace the PCI cage, follow this procedure:
1. Replace the I/O card(s) in the PCI cage if you have not already done this. Otherwise,
skip this step. To replace the I/O cards, complete the procedure in the section "I/O Card
Replacement" found in this chapter.
2. Push down on the PCI cage handle and on the back of the PCI cage. Next, rotate the
PCI cage handle downward. This will secure the PCI cage in the workstation. See
Figure 1-36.
Figure 1-36. Placing the PCI Cage into the Workstation
3. Complete the procedure in the section "Removing the CD Drive" (steps 1 through
3; in this chapter), "Removing the DAT Drive" (steps 1 through 5; in Appendix
C), or "Removing the Flexible Disk Drive" (steps 1 through 5; in Appendix D).
4. Complete the procedure in the section "Replacing the Front Bezel and Top Cover"
found in this chapter.
5. Connect and turn on the power to your system.
Chapter 1
Remove/Replace System Components
Removing/Replacing System Components
PCI Cage
Handle
PCI Cage
PCI Cage Cover
Slide Lock
Slide Lock Slot
35