Replacing The Dat Drive - HP b2600 Supplementary Manual

Replacing the DAT Drive

To replace the DAT drive, follow the procedure in this section. Note that this procedure assumes
you already have a SCSI card and cable installed in your system.
Remove the current DAT drive if you have not already done this. Otherwise, skip this step. To
1.
remove the DAT drive, follow the procedure in the section "Removing the DAT Drive" found
in this appendix.
2. Place the DAT drive brackets as shown in
holes with the threaded screw holes of the DAT drive and screw in the four bracket mounting
screws as shown in
Figure C-9 Replace the DAT Drive Bracket on the DAT Drive
DAT Drive
Bracket
3. Connect the DAT drive power and SCSI cables to their connectors located on the back side of the
DAT drive and slide the DAT drive into the DAT drive bay. See
and power cables, you will have to run them through the back of the DAT drive bay and out the
front. Note that these cables are keyed for easy connection.
Figure C-10 Connect the DAT Drive's Cables
Power Cable
DAT Drive
Appendix C
.
Figure C-9
DAT Drive
DAT Drive
Bracket
. Next, align the brackets and their screw
Figure C-9
Bracket Mounting Screws
Figure C-10
Remove/Replace DAT Drives
Replacing the DAT Drive
Bracket Mounting Screws
. To connect the SCSI
DAT Drive Bay
SCSI Cable
SCSI Terminator
91